Yesterday I installed my SEGR kit. I want to send a big "thank you" to Nathan for building the kit for me. He did a fantastic job and he's a nice guy to boot.
Also, I'd like to say thanks to the whole crew who put the SEGR build into motion.
With regard to my installation, I soldered all of my connections. I found that the instructions were very good. I mounted the SEGR onto the backside of the flip down panel under the steering column. It's easily accessible and I didn't have to worry about a low mounting point if my Jeep were partially submerged. The velcro supplied in the kit made the mounting extra easy. From start to finish it took me about 3 hours (this included time for an oil change too). This was with a few breaks, double checking wires and taking extra time to ensure a clean install especially with the rewrapping of the ECM wiring harness. I could've done it a bit quicker but it was my day off anyway.
I changed the oil at the same time so hopefully I'll see cleaner oil for longer periods of time. I've already noticed a slight increase in fuel economy but I don't have enough miles to make an accurate assessment of the true mileage yet.
Thanks again guys!
Tim
Login
Register
FAQ
Search
