All,

I know there was a previous post on how to check the SEGR for proper function. A friend of mine put the kit together and we want to make sure it works right before install in the JEEP.

If anyone could help me out with the procedure I would really appreciate it.

_________________
bigugly

2006 Liberty CRD
Power Box CR
Racor Fuel Filter Housing
Provent
Assembling SEGR
Suncoast T/C
No muffler

Turbo Tim is who I thought is the inventor and UFO assembles kits for others, I am sure his look better than mine does.
I found the drawings that were posted and downloaded them for mine.
I have yet to finish up and install it.
Work and Honey do are so demanding.

_________________
2006 Pearl Green CRD
Magnaflow 2 1/2" Cat Back
KJ Extra Leg Room Brackets, Carter Lift Pump, V6 Airbox, ORM
Fuel cooler, Oil Separator, Progard 7
Gauges EGT Boost Trans Temp Oil Pres, Michelin LXT AT2 245 70 R16
7,000# Draw Tight hitch, PML EX Deep Trans Pan
Centrifuge, SunCoast, Transgo, RAM TCM, InMotion Stage 2
Wife's 99 TDI VW Beetle

your diagrams are wrong for the new board connections
http://img530.imageshack.us/img530/1940/segrpic.jpg

Someone else here also found out that you can get the transmission sense (T41 Sense) at the engine computer connector C2-17. This way you don't have to go over to the transmission computer to get it for the SEGR.
I don't know how I missed that one, but it was a good catch!

when your done testing
use this for wiring install
http://www.lostjeeps.com/forum/phpBB3/vie ... hp?t=27359