| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| OME question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=30434 |
Page 1 of 1 |
| Author: | Ronnie Helmo [ Tue Mar 11, 2008 6:50 pm ] |
| Post subject: | OME question |
All, I hope this question has not been answered too many times - if it has I am truely sorry, I did try the search. Anyway, I ordered OME 790, 948 and dampers. The question that I have is how much lift should this give me over a stock 06 CRD? I currently have the RRO combo lift that gave me ~2in. Thanks in advance. -Dr. Dave |
|
| Author: | Ronnie Helmo [ Tue Mar 11, 2008 7:41 pm ] |
| Post subject: | |
More specifically I am asking are there any spacers needed? According to AllJ's site there are none - right? Thanks in advance. -Dr. Dave |
|
| Author: | tjkj2002 [ Tue Mar 11, 2008 8:02 pm ] |
| Post subject: | |
Ronnie Helmo wrote: More specifically I am asking are there any spacers needed? According to AllJ's site there are none - right? Thanks in advance. No spacers because it's pretty darn hard to get those 500lbs springs compressed enough without the spacers as it is.
-Dr. Dave |
|
| Author: | ATXKJ [ Tue Mar 11, 2008 8:16 pm ] |
| Post subject: | |
All-J's tried a small spacer on the CRD Frankenlift however the CRD has a shorter axle on the drivers side, this resulted in a more difficult install and several folks ripped CV boots, so they decided that it was better without the spacer - slightly less lift but you don't tear up things when you install it. (and the stock 410lb's were hard with a wall mount spring compressor - not sure about the best way to handle the 500lb ones) |
|
| Author: | Ronnie Helmo [ Tue Mar 11, 2008 8:35 pm ] |
| Post subject: | |
guys, Thanks for the resonses. I was afraid that my question was not clear and both of your answers were exactly what I was looking for. Thanks again. -Dr. Dave |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|