LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Speaker replacement
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=30644		 Page 1 of 1
Author:  biggiefl [ Mon Mar 17, 2008 3:01 pm ]
Post subject:  Speaker replacement
I searched and I looked but no info was found...so how do I remove the speaker from front doors? Do I need to remove the whole panel or does the grill come off? I have removed many panels before but just wondering if there are any tricks or just start yanking?
Author:  JIMMY JEEP [ Mon Mar 17, 2008 5:03 pm ]
Post subject: 
You have to take the whole door panel off, one or more screws and then just plastic clips (a trim tool helps) be careful when disconnecting the door opening handle from the rod ,dont be to rough. And before you start if you have premium sound system i believe you cant change the speakers so easy as the originals have the amp built into them.
Author:  Reflex [ Mon Mar 17, 2008 5:08 pm ]
Post subject: 
Just did this a couple months ago. Jimmy is correct, be careful and realize that there are two screws that have to be removed, one in the handle and one in the latch.
Author:  jinstall [ Mon Mar 17, 2008 6:06 pm ]
Post subject: 
It is easy just take your time. If you plan on upgrading later with a amp then run your speaker wires now. It saves time later. I used the factory brackets to mount 6.5" Focal 165V Editions in the doors and the tweeters in the dash. The imaging is not the best but with power it gets the vocals there.
Author:  biggiefl [ Mon Mar 17, 2008 11:56 pm ]
Post subject: 
Yes I have the premium Infinity system...wife blew the speaker out(about a year ago) and now I have 38k on it and am screwed with the 36k warranty...should I try the dealer anyway? It is only the drivers door woofer.
Author:  Uffe [ Tue Mar 18, 2008 3:36 am ]
Post subject: 
Getting to the speaker is easy, as described by others.

Two screws holds it in place.

One in door handle, one in door latch. The one in the latch is behind a plastic cover which can be pried off with a screwdriver, but be gentle!

When you got the trim off (don't use a tool, you can just use your fingers and hands to pry it up) reach behind it and untangle the door latch "stick" which connects the door latch to the actualy mechanical door "latch" which keeps the door in place. You need to reach to it, pry back a piece of snap-on plastic and lower the rod out of the plastic holder.

Then you need to take care of the door lock "bolt" that comes out of the trim. Make sure you don't bend the rod which holds it in place.

It's an easy job, but best of luck anyway :)
Author:  JIMMY JEEP [ Tue Mar 18, 2008 12:06 pm ]
Post subject: 
Uffe you can use your fingers but a trim tool designed for the job reduces the risk of breaking the trim clips.
Author:  Reflex [ Tue Mar 18, 2008 12:51 pm ]
Post subject: 
JIMMY JEEP wrote:
Uffe you can use your fingers but a trim tool designed for the job reduces the risk of breaking the trim clips.

Where would you get one? I ended up using my fingers but I'd have much preffered the proper tools for the job...
Author:  hyedipin [ Tue Mar 18, 2008 4:20 pm ]
Post subject: 
Reflex wrote:
JIMMY JEEP wrote:
Uffe you can use your fingers but a trim tool designed for the job reduces the risk of breaking the trim clips.

Where would you get one? I ended up using my fingers but I'd have much preffered the proper tools for the job...


Crutchfield
or
Wife's spatula.


pix: http://gallery.jeepprojects.com/categor ... ?cat_id=12
Author:  Joe Romas [ Tue Mar 18, 2008 4:45 pm ]
Post subject: 
Reflex wrote:
JIMMY JEEP wrote:
Uffe you can use your fingers but a trim tool designed for the job reduces the risk of breaking the trim clips.

Where would you get one? I ended up using my fingers but I'd have much preffered the proper tools for the job...


Harbor Frieght. Item number 95214 $3.49 4 piece set. I would send a link but there site is dog slow just now.
Author:  biggiefl [ Fri Mar 21, 2008 12:54 am ]
Post subject: 
Wow...you guys are great...all I need is a dog slow to help me I guess? :) Maybe I will just use the door tool I got from JC Whitney in 1986???
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/