Thanks for the reply
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Another CEL question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=31290 |
Page 1 of 1 |
| Author: | Wyokaboy [ Mon Apr 07, 2008 12:05 am ] |
| Post subject: | Another CEL question |
Wife tells me the CEL came on the othe day. Mileage going down hill, a little harde to start in the morning ect. After reading through a few post I think it's the MAP. So, I pull it and sure enough it needs to be cleaned. Also clean the MAF while I was at it. Reinstalled both and installed the neg. battery cable...still ahve CEL. Run to town and have it checked at Auto Zone. The code is P01263 fuel air metering. Was this the MAP/MAF and I just need to have the code cleared or is it something else? Thanks Kevin |
|
| Author: | 05infernoCRDL [ Mon Apr 07, 2008 12:12 am ] |
| Post subject: | |
CEL's clear after a few cool down cycles... might just need that for the light to go off |
|
| Author: | Wyokaboy [ Mon Apr 07, 2008 12:18 am ] |
| Post subject: | |
Thanks for the reply
|
|
| Author: | 05infernoCRDL [ Mon Apr 07, 2008 12:27 am ] |
| Post subject: | |
no problem... it will prolly go out tomorrow morning if you decide to go have it cleared... that is what happened to me. how did you clean the MAP? |
|
| Author: | gmctd [ Mon Apr 07, 2008 12:23 pm ] |
| Post subject: | |
'Zone shoulda been able to clear the DTC(s) - wha' hoppened, there? Clean the MAP with Diesel fuel - don't get any in the electrical connector |
|
| Author: | 05infernoCRDL [ Mon Apr 07, 2008 12:31 pm ] |
| Post subject: | |
gmctd wrote: 'Zone shoulda been able to clear the DTC(s) - wha' hoppened, there?
Clean the MAP with Diesel fuel - don't get any in the electrical connector when i went to the avdanced they don't have a reader... i used MAF sensor cleaner on mine... did i F it up? |
|
| Author: | gmctd [ Mon Apr 07, 2008 2:48 pm ] |
| Post subject: | |
Prolly not, Trevor - long as you didn't get any in the electrical connector - if it's still working, likely you did good |
|
| Author: | 05infernoCRDL [ Mon Apr 07, 2008 3:55 pm ] |
| Post subject: | |
gmctd wrote: Prolly not, Trevor - long as you didn't get any in the electrical connector - if it's still working, likely you did good
okay.. i have no CEL so i am guessing it is fine... and i can hear the Boost when in a tunnel/ |
|
| Author: | Wyokaboy [ Mon Apr 07, 2008 10:28 pm ] |
| Post subject: | |
I also did the ORM, and the wife reports it has alot more zip  . I used brake cleaner on the MAP and MAF cleaner on the MAF. Still trying to figure out what the 1263 code is?
|
|
| Author: | gmctd [ Mon Apr 07, 2008 11:52 pm ] |
| Post subject: | |
P1263 could be Glow Plug #2 open, courtesy of AutoEnginuity, yer user-friendly pcware laptop scantool and invaluable companion, having acquired a KJ CRD.............. |
|
| Author: | dirtmover [ Thu Apr 10, 2008 1:29 pm ] |
| Post subject: | |
Yes it's a glow plug according to my Innova. I had the dealer change #3 plug a few months ago after it threw a P1265 code. |
|
| Author: | cerich [ Thu Apr 10, 2008 7:31 pm ] |
| Post subject: | |
dirtmover wrote: Yes it's a glow plug according to my Innova. I had the dealer change #3 plug a few months ago after it threw a P1265 code.
one of the early thing some folks discoved with our beasties that hasn't been mentioned in awhile is that the computer brain was mixed up on what cylinder was what when it camr to reporting glow plus. So it may not be cylider #2 but another cylinder with a bad glowplug. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|