I have the Rusty's suspension lift (brand new - not installed yet) and an 06 CRD. I know there is a lot of talk about sagging. If I picked up the OME790 springs which are the 500lb ones would that be all I would need to do to correct the sag situation as well as have an equal lift to the rear? Would I need to add the strut plates that Rusty's offers here: http://tinyurl.com/6p9hjk ? Would I need to do anything in the clevis department? I've read a lot about sagging, but not much on correction to the point of how it was when the kit is new. I want to make sure I can still run 31's. Thank you to all in advance.
-c

Anyone with knowledge on the OME CRD front springs got any advice?

The CRD Franken lift is only advertised as a 2-2.25" lift. Will adding strut plates and/or a clevis lift cause problems with the upper ball joints or the cv joints on the crd?

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster