| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rusty's suspension lift - change the springs? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=31616 |
Page 1 of 1 |
| Author: | ccattie [ Wed Apr 16, 2008 7:07 pm ] |
| Post subject: | Rusty's suspension lift - change the springs? |
I have the Rusty's suspension lift (brand new - not installed yet) and an 06 CRD. I know there is a lot of talk about sagging. If I picked up the OME790 springs which are the 500lb ones would that be all I would need to do to correct the sag situation as well as have an equal lift to the rear? Would I need to add the strut plates that Rusty's offers here: http://tinyurl.com/6p9hjk ? Would I need to do anything in the clevis department? I've read a lot about sagging, but not much on correction to the point of how it was when the kit is new. I want to make sure I can still run 31's. Thank you to all in advance. -c |
|
| Author: | Jeepjeepster [ Thu Apr 17, 2008 10:44 pm ] |
| Post subject: | |
Anyone with knowledge on the OME CRD front springs got any advice? The CRD Franken lift is only advertised as a 2-2.25" lift. Will adding strut plates and/or a clevis lift cause problems with the upper ball joints or the cv joints on the crd? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|