| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Scangauge ll Anywhere Cheaper? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=31792 |
Page 1 of 1 |
| Author: | fastRob [ Tue Apr 22, 2008 5:34 pm ] |
| Post subject: | Scangauge ll Anywhere Cheaper? |
Found this link on SlickDeals.net: http://forums.slickdeals.net/showthread ... 0&t=803181 A Scangauge ll for $139.84 shipped through Amazon.com Anyone found a better deal? |
|
| Author: | honey_don't [ Tue Apr 22, 2008 6:24 pm ] |
| Post subject: | |
that is $10 less than the cheapest I have seen |
|
| Author: | fastRob [ Wed Apr 23, 2008 6:19 pm ] |
| Post subject: | Link Expired, Deal Dead |
The link has expired, the deal is dead. I snoozed. |
|
| Author: | honey_don't [ Wed Apr 23, 2008 6:22 pm ] |
| Post subject: | |
There were only two available when I checked out your link. Here is the best price you are likely to find, good til 30 April: http://www.3n1autocomputer.com/groupbuyTDIclub.html |
|
| Author: | Cowcatcher [ Wed Apr 23, 2008 7:30 pm ] |
| Post subject: | |
I got us a factory direct deal a year ago for $149. Search for it here to find the order code. |
|
| Author: | ernestgj [ Fri Apr 25, 2008 9:45 am ] |
| Post subject: | |
Scangauge website says: "Jeep Liberty with the diesel engine does not report fuel use or trip functions and some of the gauges. Unless the recall ECU software update has been completed." So what exactly doesn't work? Don't really care about the fuel use... but the reason to buy it is to get the gauges, so which ones don't work? Greg |
|
| Author: | Cowcatcher [ Fri Apr 25, 2008 9:57 am ] |
| Post subject: | |
Interesting comment. The SGII works fine until it doesn't then virtually none of it works. The time between when it does and when it doesn't can be counted in tens of minutes and hours. I have had it quit on two occassions when the OD also became disengaged at 70 MPH. HEART STARTER!!!!!  When it works it works on most functions but the trip mileage won't because it dosesn't stay engaged day after day after day. When it shuts down only a couple of features work like RPM.
|
|
| Author: | honey_don't [ Fri Apr 25, 2008 10:11 am ] |
| Post subject: | |
Here is an email reply I got from LL in March. Asked about x-gauge for trans temp and mentioned the shutdown. Hi, Unfortunately we do not have Jeep/Chrysler specific commands yet. Keep an eye on our website for updates on that. As far as the turning off, if you have not tried it yet you may be able to stop it from happening if you slow down the ScanGauge. MORE>MORE>RATE>SLOW It seems to help some case, but not in others. I wish I could be of more help. Regards, Joey Snyder Linear Logic |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|