Anyone knows how many wires should come factory terminated in the back of the OBDII connector?

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Just for the record, that's OBD2 with CAN - ~ half those for strictly OBD2, pre-'02 - others are strictly oem-dependent, GM-DCJ-Ford-etc

_________________
'05 CRD Limited
Pricol EGT, Boost
GDE Hot '11; EDGE Trail switched
SEGR; Provent; Magnaflow;
Suncoast T\C, Transgo Tow'n'Go switch;
Cummins LP module, Fleetguard filter, Filterminder
2.5" Daystar f, OME r; Ranchos; K80767's, Al's lifted uppers
Rubicons, 2.55 Goodyears
Four in a row really makes it go

Yes, and pin 7 is redundantly noted because it access the PCM(ECU and TCU) in the gasser and the diesel pin 7 accesses the ECU.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Thanks for the replies. I have an 06 CRD and there are only two wires terminated in the back of the OBDII connector. I bought it used and have had no issues with it. I am not sure if someone previously may have modified this connector and for what reason . Any ideas?

Which two?

_________________
'05 CRD Limited
Pricol EGT, Boost
GDE Hot '11; EDGE Trail switched
SEGR; Provent; Magnaflow;
Suncoast T\C, Transgo Tow'n'Go switch;
Cummins LP module, Fleetguard filter, Filterminder
2.5" Daystar f, OME r; Ranchos; K80767's, Al's lifted uppers
Rubicons, 2.55 Goodyears
Four in a row really makes it go

Purely speculation, but maybe they were trying to block the dealership's access. Only reason I can think of.

_________________
Matt B.

05 Limited CRD. Bought it new. 112k on the clock now.

GDE Eco-tune, rear differential drain plug (drilled and tapped the pumpkin), transmission pan drain plug, Fumoto oil valve, fuel filler neck restriction removed, front hitch, Hayden fan clutch, Sears P1 battery since 08, Mobil 1 5w40, 5 volt glow plugs, DIY timing belt at 109k