I noticed today that the paint is rubbing off on the drivers side door edge where it meets the bottom of the windshield. Currently is down to bare metal. I want to know if anyone else has this issue. Before I call Jeep customer service.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| CRD Paint issue http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=33742 |
Page 1 of 1 |
| Author: | jinstall [ Mon Jun 30, 2008 3:54 pm ] |
| Post subject: | CRD Paint issue |
I noticed today that the paint is rubbing off on the drivers side door edge where it meets the bottom of the windshield. Currently is down to bare metal. I want to know if anyone else has this issue. Before I call Jeep customer service.
|
|
| Author: | dgeist [ Tue Jul 01, 2008 8:39 am ] |
| Post subject: | |
That's pretty severe. The only thing even close I've seen is the rear hatch/upper support rusting on the weld seam, but yours is obviously not rust... Is that rub point against the weatherstripping? I've not seen foam rubber cut through paint before.... Might be a defect in the original paint that just let go with a couple years of soft contact. You should at least be able to have one of their body guys to a professional job with some matching touch-up since it doesn't appear to be an outer surface. |
|
| Author: | jinstall [ Tue Jul 01, 2008 1:14 pm ] |
| Post subject: | |
OK. Yes it is from the weather stripping. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|