| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Engine lost power & rattled... http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=35204 |
Page 1 of 1 |
| Author: | Topan [ Tue Aug 19, 2008 11:58 am ] |
| Post subject: | Engine lost power & rattled... |
Hi guys, I had a very strange thing on my 2006 CRD (30 K miles) Engine not yet warm, i left a greenlight by accelerating smoothly. When it shifted to 3rd gear it lost almost all its power. Like the engine was running on 1 or 2 cylinders. I got to a parking area, openned the hoot and the engine was rattling like hell. Closed the hoot, drove 1 mile: absolutely without power, average speed approx. 10 miles/hour and rattling Stopped the engine, called the TCS (great Swiss stuff that will get you out of any poopoo). Waiting for the mechanics to arrive, i started the engine again: Runned fantastic !!! No rattling , all the cylinders where back and got all the CRD power !!! No error lights on the dashboard either !! The mechanic connected the toughbook: no error message either !!! Since there is no trace of the problem, my mechanic cant do anything ! Does anyone had it ? Any idea of what it is ? How to solve it? Many thanks Cheers from Swiss Alps !! |
|
| Author: | Joe Romas [ Tue Aug 19, 2008 12:05 pm ] |
| Post subject: | |
Possibly a clogged fuel filter |
|
| Author: | JL Rockies [ Tue Aug 19, 2008 12:07 pm ] |
| Post subject: | |
Since it was fine after the next start up, I'd say the computer went into limp mode. I don't know why it did, but the computer saw something it didn't like and was protecting the engine. I've had it happen couple of times. |
|
| Author: | gmctd [ Tue Aug 19, 2008 12:12 pm ] |
| Post subject: | |
Classic limp mode: cycle IGN switch, ECM resets, all ok - should be an error down in archives readable only by Starscan - likely a fuel supply issue, as suggested |
|
| Author: | Cowcatcher [ Tue Aug 19, 2008 1:19 pm ] |
| Post subject: | |
It is the classic "air in fuel" syndrom. I bet you didn't get any CEL, right. Was it a hot day too and had you been driving. RPM's up buy no power and like running on 2 cylinders? AIR IN FUEL! Check out the heater connection on the filter head and see if there is fuel in it. Replace the head and get a lift pump. |
|
| Author: | BlackLibertyCRD [ Tue Aug 19, 2008 1:51 pm ] |
| Post subject: | |
I had that happen to me several times, even had it go in limp mode while driving at highway speed. Installing a lift pump fixed it. |
|
| Author: | kcfoxie [ Tue Aug 19, 2008 3:13 pm ] |
| Post subject: | |
I second the "push the pump button on the filter housing" resolution IE: I bet that there is air in your fuel line, thus resulting in limp mode. I drove like 5 miles in limp mode once. The truck had trouble going up not very steep hills. I was terrified I broke it. Then I found it we bought the car pre-broken from Chrysler |
|
| Author: | Zonie [ Tue Aug 19, 2008 5:58 pm ] |
| Post subject: | |
Sounds exactly like what happened when I put in a full tank of B100 and clogged my fuel filter. It flushed through and it never happened again, but rattled me at the time. |
|
| Author: | Bill.Barg [ Tue Aug 19, 2008 6:05 pm ] |
| Post subject: | |
Exactly the same for me. No CEL. Has not happened to me since the In tank lift pump mod ! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|