Where might I purchase a Brake Controller Wiring Harness?
Any suggestions on a brake controller as well?
The trailer is getting new brakes and it is time to test this rascal out with a load.

_________________
'06 Jeep Liberty Sport CRD with: GDE Hot Flash and Tranny Flash, ehm, Cummins fuel pump, 3" Magnaflow muff, Moog K3199's, Skids, 225-75-16 10 ply, OME springs, Euro T/C, Shift kit, Trans cooler w/thermal bypass, Bigboy bkt, Samco CAC, Brake controller, Trans temp gauge, Al's Upper Arms

I got the Teknosha Prodigy (sp?). There isn't a wiring harness for it that works on the jeep as there is for some of the dodges. Its only 3 wires though and relatively easy.

_________________
Ryan
2006 Ford F-250 PSD CC FX4
**GONE**
2005 Jeep Liberty CRD
SAMCO Hoses//GDE Tune//PML Trans Pan//TransGo HD Shift Kit//MBRP Exhaust

1986 2R Mustang SVO

Do you have a factory towing package?
Do you have a EVIC?

Both of these questions are revelent to your question. As stated "there's no brake harness" But you might have the blue wire depending an the answeres to the above. Also see this thread.
http://www.lostjeeps.com/forum/phpBB3/vie ... hp?t=33499

_________________
Atlantic Blue 06 CRD Limited (his)
Joined by a 2000 XJ Classic (hers)

My Prodigy has 4 wires, 12v hot, 12v negative, trailer brake wire, and wire to brake light/pedal.

_________________
08 Elantra SE daily driver
2001 F-250 powerstroke

_________________
'06 Jeep Liberty Sport CRD with: GDE Hot Flash and Tranny Flash, ehm, Cummins fuel pump, 3" Magnaflow muff, Moog K3199's, Skids, 225-75-16 10 ply, OME springs, Euro T/C, Shift kit, Trans cooler w/thermal bypass, Bigboy bkt, Samco CAC, Brake controller, Trans temp gauge, Al's Upper Arms