shows you how much i know
Figured it was MAP sensor just because code description is: P0069 MAP- Manifold absolute pressure - Barometric Pressure correlation
Are you talking about the MAF sensor being the issue mayby? Thanks
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| purchaseing MAP sensor http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=36003 |
Page 1 of 1 |
| Author: | mngoat01 [ Wed Sep 17, 2008 10:20 am ] |
| Post subject: | purchaseing MAP sensor |
anyone have a spot to buy a sensor cheaper then dealer. They wanted over $100 at the dealer. I don't know if mine is bad but can't get the CEL off for more then 3 days despite what i do as far as cleaning, new air filter, checking hoses and such. So i'm almost due for oil change so i figured i'd ordered a new one and change oil at the same time as install and see if that works. Thanks |
|
| Author: | ATXKJ [ Wed Sep 17, 2008 10:42 am ] |
| Post subject: | |
I've had good results Mopar Parts America http://www.trademotion.com/partlocator/index.cfm?action=getJointLocator&siteid=214583&chapter=§ionids=3,2413&groupid=10046&subgroupid=61072&make=17&model=Liberty&year=2005&catalogid=1&displayCatalogid=0 |
|
| Author: | mngoat01 [ Wed Sep 17, 2008 10:45 am ] |
| Post subject: | |
Thanks for the link. $36 is a lot better then $100. Thanks, Again. |
|
| Author: | Hjalti [ Wed Sep 17, 2008 1:38 pm ] |
| Post subject: | Is cleaning the MAP sensor OK? |
I´m wondering if cleaning the MAP sensors is causing premature failure? I have cleaned mine couple of times with carb cleaner and it failed a few weeks ago (code 105). It seems from reading the board that there are a number of instances of this lately. |
|
| Author: | mngoat01 [ Wed Sep 17, 2008 4:44 pm ] |
| Post subject: | |
I don't know if cleaning has been giving issues. I'm still just throwing P0069 code, resets itself, then throws code a few days later. Mine always gets thrown at an idle. I have been just useing Diesel fuel to clean mine. Didn't have much trouble until after installing SEGR. Don't know if there is a correlation there or not. |
|
| Author: | MrMopar64 [ Wed Sep 17, 2008 5:42 pm ] |
| Post subject: | |
A P0069 is going to be more a result of the Intake Air Pressure Sensor which should be located on the airbox. |
|
| Author: | mngoat01 [ Wed Sep 17, 2008 6:55 pm ] |
| Post subject: | |
shows you how much i know Figured it was MAP sensor just because code description is: P0069 MAP- Manifold absolute pressure - Barometric Pressure correlation
Are you talking about the MAF sensor being the issue mayby? Thanks |
|
| Author: | ATXKJ [ Wed Sep 17, 2008 7:06 pm ] |
| Post subject: | |
MAF is on top of the airbox, Intake Air Pressure Sensor is on the side - unplug it and you have power problems |
|
| Author: | mngoat01 [ Wed Sep 17, 2008 7:16 pm ] |
| Post subject: | |
i'll take a look. Thanks for the help. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|