UFO wrote:
1" OD may be tight, but should work. For filling with B100, I use a 3/4" ID (1"OD) PVC hose, and it just fits.
Cool. I'll stick with 3/4", then. Besides. Looks like the 1" are out of stock
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Inside Diameter of Filler Neck? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=36761 |
Page 1 of 1 |
| Author: | dgeist [ Tue Oct 14, 2008 3:05 pm ] |
| Post subject: | Inside Diameter of Filler Neck? |
Any happen to know the inside diameter of the filler neck on the US CRDs? I'm about to buy some fuel cans that have either 3/4 or 1' neck. I'd like to get the larger but don't know if it'll fit (and I'm not at the same place as the jeep is). Thanks. Dan |
|
| Author: | UFO [ Tue Oct 14, 2008 3:25 pm ] |
| Post subject: | |
1" OD may be tight, but should work. For filling with B100, I use a 3/4" ID (1"OD) PVC hose, and it just fits. |
|
| Author: | dgeist [ Tue Oct 14, 2008 3:36 pm ] |
| Post subject: | |
UFO wrote: 1" OD may be tight, but should work. For filling with B100, I use a 3/4" ID (1"OD) PVC hose, and it just fits.
Cool. I'll stick with 3/4", then. Besides. Looks like the 1" are out of stock
|
|
| Author: | geordi [ Wed Oct 15, 2008 1:01 am ] |
| Post subject: | |
Of course, you could always pull the filler neck and dremel out that stupid interior plastic crap. I don't have any problems filling up at the thunder-nozzles now at Flying J... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|