No worries ....my wife's, mother's, sister's, daughter's, husband's, manager, has got pins as well ....got the measurements from them ...
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Camshaft locking pins http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=37338 |
Page 1 of 1 |
| Author: | Sonix [ Fri Nov 14, 2008 3:56 am ] |
| Post subject: | Camshaft locking pins |
I need to set the timing on my 2.8, and according to the manual, I need two camshaft locking pins, to get the right position, and lock them in place ... Does anyone have an idea what else I can use for this? ... maybe something I can make myself? .. |
|
| Author: | onthehunt [ Fri Nov 14, 2008 6:20 am ] |
| Post subject: | |
Too bad your not closer. I would lend you mine. I could take measurements... |
|
| Author: | Sonix [ Fri Nov 14, 2008 7:47 am ] |
| Post subject: | |
No worries ....my wife's, mother's, sister's, daughter's, husband's, manager, has got pins as well ....got the measurements from them ...
|
|
| Author: | warp2diesel [ Fri Nov 14, 2008 8:08 am ] |
| Post subject: | Please post the dimensions |
I have a lathe and made pins for other engines before, not hard to do. |
|
| Author: | tonycrd [ Fri Nov 14, 2008 8:43 am ] |
| Post subject: | |
If you are just changing the timing belt you could use a piece of chalk and mark the 2 camshaft gears so you place the new belt in the exact same position. Anyway, that's what I did. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|