| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Which pin to yank on the OBD II plug.... http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=37977 |
Page 1 of 1 |
| Author: | warp2diesel [ Sat Dec 06, 2008 11:29 am ] |
| Post subject: | Which pin to yank on the OBD II plug.... |
....or which wire do you put a hidden switch on to block Dealer ECM R@PE (Flash & Screw You Over routine)? Since I am out of Warranty, the only thing that will get me into the dealer is a Recall 
If I hand over money to a chip tuner the last thing I want is to get F'ed with an unwanted flash. Any ideas 
|
|
| Author: | Sir Sam [ Sat Dec 06, 2008 10:57 pm ] |
| Post subject: | |
Don't mess with pins. Remove your good plug and hide it Goto the junkyard and grab the odbii connector from any other vehicle. Install dummy connector. |
|
| Author: | dieselenthusiast [ Sun Dec 07, 2008 2:19 am ] |
| Post subject: | |
Sir Sam wrote: Don't mess with pins.
Remove your good plug and hide it Goto the junkyard and grab the odbii connector from any other vehicle. Install dummy connector. X2 ................... what are you wanting to run? This is what I would run: http://www.parleysdieselperformance.com ... ct/DR-2030 Here's a testimony: http://drperformance.com/shop/product_r ... views_id=3 I run the Workhorse Module, which is made by Dr. Performance in my Cummins. I average 25 mpg in a 4X4 Quad Cab. The Workhorse Module gave me a solid 2 mpg increase and doesn’t throw codes. It’s undetected when you take it out. Here are my Cummins modifications: PSM air intake Amsoil Air Filter COOL HOSE TAG (Turbo Air Guide) CFM+ intake Workhorse Module Factory 4” with Aero Turbine Muffler Amsoil by-pass Amsoil Series 3000, 5W-30 Michelin LTX @ 75 PSI Amsoil Cetane additive Amsoil Concentrate fuel additive |
|
| Author: | tulsa [ Sun Dec 07, 2008 11:33 am ] |
| Post subject: | |
Sir Sam wrote: Don't mess with pins.
Remove your good plug and hide it Goto the junkyard and grab the odbii connector from any other vehicle. Install dummy connector. Sam, simple and elegant solution. Lewis |
|
| Author: | warp2diesel [ Sun Dec 07, 2008 12:28 pm ] |
| Post subject: | RE: Don't mess with pins |
Sir Sam wrote: Don't mess with pins.
Remove your good plug and hide it Goto the junkyard and grab the odbii connector from any other vehicle. Install dummy connector. Sounds good, even the best ECM rapist can't do it to a dead plug. Thanks 
|
|
| Author: | Uffe [ Mon Dec 08, 2008 3:07 am ] |
| Post subject: | |
Don't go to the junkyard, it's too complicated and tiresome. THIS is what you really need: 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|