Hi all, I finally finished fitting my so long thought of/ discussed and desired lift.

It consists of:

OME 927/948
Koni heavy track front shocks
Rancho RSX 17004 rear shocks
Rusty's top plates
3 ring clevis
+1 upper isolater on the rear
JBA gen 3.5 upper control arms
Terraflex front bumpstops
Cut to size rubber mallets rear bumpstops

Here's what I got:



Here's what the front looks like:



Test driven it for a little bit today, very happy with it! Now need some bigger tires...fast..

_________________
Cherokee 2,5 CRD: sold - Wrangler TJ 2.5: gone - Touareg V10 TDI: new toy

Solo Liberty en Español: Jeepliberty.es

Yeah and some new brake discs, look bad in the pic

Yes, new tires. Should look amazing, nice job.

_________________
'05 Liberty CRD B100, SEGR - SOLD

'01 Beetle TDi B100, EGR delete
'83 Mercedes 240D B100, no EGR

--- SEGR Builder ---

Nice job, looks good

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.

I don't think your rotors look bad, If it aint broke don't fix it!

Looks and should work great.
Be careful, the higher center of gravity makes it a little tippy, just like mine is.
When you load it down with weight it will ride really well.
Good luck.

_________________
'06 Jeep Liberty Sport CRD with: GDE Hot Flash and Tranny Flash, ehm, Cummins fuel pump, 3" Magnaflow muff, Moog K3199's, Skids, 225-75-16 10 ply, OME springs, Euro T/C, Shift kit, Trans cooler w/thermal bypass, Bigboy bkt, Samco CAC, Brake controller, Trans temp gauge, Al's Upper Arms