| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| glow plug question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=40252 |
Page 1 of 1 |
| Author: | ATXKJ [ Sun Feb 15, 2009 4:50 pm ] |
| Post subject: | glow plug question |
Okay p1263 - glow plug error - I pulled the connector ohm'ed the contacts 3 @ 0.7 ohms - 1 @ 120ohms. but I didn't see any numbers - and the wire is wrapped so it's not obvious which cylinder it's going too. is there a quick way to tell? |
|
| Author: | retmil46 [ Sun Feb 15, 2009 5:38 pm ] |
| Post subject: | |
Offhand, wiring diagram and compare color codes? |
|
| Author: | ATXKJ [ Sun Feb 15, 2009 5:45 pm ] |
| Post subject: | |
Okay - it says the stripes are different 1 Rd/Wt 2 Rd/Br 3 Rd/Yl 4 Rd/Or That'll work Thanks |
|
| Author: | ac5501 [ Tue Feb 17, 2009 1:41 pm ] |
| Post subject: | |
ATXKJ wrote: I pulled the connector ohm'ed the contacts 3 @ 0.7 ohms - 1 @ 120ohms.
but I didn't see any numbers - and the wire is wrapped so it's not obvious which cylinder it's going too. is there a quick way to tell? Okay - it says the stripes are different 1 Rd/Wt 2 Rd/Br 3 Rd/Yl 4 Rd/Or That'll work Thanks Hold on there pardner. Had the same problem on mine. code said the #1 glow plug was bad. The colored wires only go up to the connector. After that its 4 black wires to the plugs. Problem for mine was that the harness was installed backwards. The number 1 connector pin was actually going to the #4 glow plug. We had to check the resistance on the actual plug to determine which one was bad. Since it was covered under the 7/70 we took it to the dealer and they confirmed and fixed the situation As far as a quick way to tell, disconnect the wire from the glow plug (if you can reach it) then check the resistance on the connector again. You will get an open circuit on the disconnected one. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|