Someone indicated a while back that replacing the fan clutch can be a real bear.

Anyone have any suggestions as to how to keep the time involved to a minimum (without hurting something)?

Thanks,

DOC

_________________
2005 KJ CRD Ltd Detroit TrueTrac Bilsteins G2 GDE "HOT" ECU GDE TCM "Tow Tune" "euro" TC SEGR Weeks Elbow New HG at 130K ARPs Clean CAT aFe Filter Magnaflow Exhaust EHM Cumminos In-Tank Lift Pump Hayden Fan Clutch Nylon Fan VH Enabled with GDE lower shutoff point Recalibrated Temp Gauge Tekonsha Prodigy Sears P-1 ZDDP

Doc,

That thread is still alive and moved up toward the top again with some good suggestions. Since I have made a special tool similar to the Jeep special tool the job will take me around an hour next time because I will slice the fan shroud to facilitate removal. I just haven't decided where to slice it yet.