LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Tranny Cooler Return Line
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=44917		 Page 1 of 1
Author:  DocB [ Fri Jul 10, 2009 8:11 pm ]
Post subject:  Tranny Cooler Return Line
Hello Fellas,

Quick question:

Which of the hard lines on the right (passenger) side of the transmission is the return line from the cooler?

Top or bottom?

TIA.
Author:  gmctd [ Fri Jul 10, 2009 8:22 pm ]
Post subject: 
Upper is to, lower is from
Author:  Silverdiesel [ Fri Jul 10, 2009 8:23 pm ]
Post subject: 
Well its the one from the driver's side of the bottom of the cooler-- not sure if one can see this with the stock valances/air dams in place-- one way to tell is on a cold start-- run the engine for ```5 mins and shut down and "feel " the lines coming out of stock cooler and return line will be noticeably cooler by touch.
Author:  DocB [ Fri Jul 10, 2009 10:33 pm ]
Post subject: 
Thanks. Going to install the temp sensor on Monday.
Just want to make dang sure before I cut the line.

Silverdiesel- I will trace it from the bottom of the cooler from the drivers side and will also do the feel test.

gmctd-I'm assuming "lower is from" means from the cooler and is the return to the tranny.

Just making sure.

PS- What the best tranny pan sealer/RTV you have found to use on our vehicle?

TIA.
Author:  BlackLibertyCRD [ Fri Jul 10, 2009 10:41 pm ]
Post subject: 
DocB wrote:
PS- What the best tranny pan sealer/RTV you have found to use on our vehicle?
TIA.


Use the black stuff from Jeep. It will hold the pan in place without bolts. Add bolts for extra assurance. :wink:
Author:  gmctd [ Sat Jul 11, 2009 12:52 am ]
Post subject: 
Clean the pan and trans rails with lacquer thinner, then Permatex Black RTV - lower is from cooler
Author:  DocB [ Sun Jul 12, 2009 11:11 pm ]
Post subject: 
Thanks, fellas.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/