Looking to add gauges ad need to get recommendations on gauge pods that will work. Any suggestions on sources?
Thanks!
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| A-Pillar Gauge Pods for the Liberty - Suggestions? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=45841 |
Page 1 of 1 |
| Author: | GeorgiaX [ Fri Aug 14, 2009 10:51 am ] |
| Post subject: | A-Pillar Gauge Pods for the Liberty - Suggestions? |
Looking to add gauges ad need to get recommendations on gauge pods that will work. Any suggestions on sources? Thanks!
|
|
| Author: | RTStabler51 [ Fri Aug 14, 2009 2:28 pm ] |
| Post subject: | |
gaugepods.com (LoTek) The only thing I can say is that this gauge pod wasn't a straight forward install for me compared to the others I've installed from them. |
|
| Author: | DOC4444 [ Fri Aug 14, 2009 6:59 pm ] |
| Post subject: | |
I used the LoTek 2-gauge pod for the CRD and found it required just a little trimming to make it fit perfectly. It even came with color matched "buttons" to cover the screws, though I did need to use somewhat longer screws than they provided. It was actually much less work to fit than the one I got from Banks for our old '99 Suburban. I would really like a digital module that would allow you to read most of the performance parameters from the ECU such as is available for Ford/GM/Dodge trucks. DOC |
|
| Author: | GeorgiaX [ Fri Aug 14, 2009 8:10 pm ] |
| Post subject: | |
Thanks for information... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|