My 160k crd is sending codes for egr valve. I have acquired a new one and searched for instructions that state to remove fuel fliter/water separator to access the egr. Does anyone have specific instructions for this removal?

Pretty simple, remove two nuts, loosen 2 hose clamps, remove 3 electrical connectors.....done. Keep assembly upright to keep fuel from spilling out.

_________________
Dennis
Considering sound advice, invent your own solutions
CRD

What DM said. It's not more than a ten minute job to get the fuel filter off.

Now, the EGR is a different kettle of.....whatever.

_________________
Grid power- the one true essential

2005 Liberty CRD- ARP studs, Fumoto, Hayden FC, inline Tstat, ETechno 7v GP, Platinum P1, in-tank lift pump.
1983 Volvo D24T
1981 Volvo D24
Dodge Cummins TD
Case 580B
Mitsubishi MT180 diesel
Kubota BX25 diesel

only hard part is clipping the water sensor on the bottom - because of the funky connector lock

fyi -have you checked the Noob guide yet? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=54207

_________________
2005 CRD
stuff
Skeptic quod gratis asseritur, gratis negatur