LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
Optima Yellow Top doesn't fit? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=49290 |
Page 1 of 1 |
Author: | oscillate [ Thu Jan 14, 2010 3:58 am ] |
Post subject: | Optima Yellow Top doesn't fit? |
Hiya! I'm a new CRD owner... picked up a 2005 Limited a week ago and it has a bad battery ![]() I know the CRD originally came with the red top 34R (reverse) -- but Optima doesn't make a yellow-R as far as I can tell. I don't know if I need the reverse or if it has anything to do with my problem. Is it just me or is there something I need to do to get the yellow top to fit? I'm not super mechanically inclined-- I use the Jeep mainly for in-town driving and taking my son to school, tho eventually my husband would like to add a winch and attendant lift/etc mods for his weekend use (the reason I bought the yellow top instead of the red). I may just be missing something obvious to yall on installing it... I can see searching the forums here that the yellow tops have worked for many and I'd love to understand ![]() |
Author: | ATXKJ [ Thu Jan 14, 2010 8:55 am ] |
Post subject: | Re: Optima Yellow Top doesn't fit? |
the connector is soft - it bends easily and doesn't take much to reach the post. Welcome to LOST |
Author: | linewarbr [ Thu Jan 14, 2010 11:21 am ] |
Post subject: | Re: Optima Yellow Top doesn't fit? |
If you are looking from the front of the Jeep, toward the windshield with the hood open, the positive (red) pole should be on the right and the negative (black) should be on the left. Both poles should be closer to the steering wheel-side of the battery than to the headlight-side of the battery. I replaced my battery with a yellow-top in a cruise line parking garage in Tampa on a Sunday morning. My negative battery cable had been bent to fit flush with the old battery, and I could only get it part of the way down on the pole without re-bending it. |
Author: | mikey1273 [ Thu Jan 14, 2010 6:00 pm ] |
Post subject: | Re: Optima Yellow Top doesn't fit? |
I had an AutoCraft Gold From Advance Autoparts installed in mine. the guy there did it and I didn't notice him have much trouble getting a regular group 34 in backwards. I had both cables removed when I set up my Provent filter, I did notice the Negitive was a very close fit. |
Author: | JL Rockies [ Fri Jan 15, 2010 11:17 pm ] |
Post subject: | Re: Optima Yellow Top doesn't fit? |
I rock the Yellow Top I just straightened the negative connector and I was good to go. |
Author: | oscillate [ Sat Jan 16, 2010 12:05 pm ] |
Post subject: | Re: Optima Yellow Top doesn't fit? |
Thanks so much for the help everyone-- slightly bending the negative connector out from its 90 degree position worked and I'm up and running again ![]() |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |