I have a harbor Freight scanner. I keep getting 0069. I think it is P069? I stays in for a while then clears itself. If I leave the scanner on for 4 scans it clears immediately. It comes in when I am driving around town. I think the Idle gets noisier also, but I'm not sure. ANY Ideas??
2006 CRD ~15K mi

the P only stands for powertrain, the obdii protocol supports body codes too.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

P0069 is Barometric Pressure correlation - used to determine MAP and corrected flow thru the MAF - prolly need to pull your MAP sensor and clean it up - also check your ducting between the MAF sensor and the turbo input, see if it is deformed, leaking

_________________
'05 CRD Limited
Pricol EGT, Boost
GDE Hot '11; EDGE Trail switched
SEGR; Provent; Magnaflow;
Suncoast T\C, Transgo Tow'n'Go switch;
Cummins LP module, Fleetguard filter, Filterminder
2.5" Daystar f, OME r; Ranchos; K80767's, Al's lifted uppers
Rubicons, 2.55 Goodyears
Four in a row really makes it go

I should have said this sooner.
Cleaned the sensor code cleared for 5K mi.
Cleaned the sensor.

Al