So I got the Libby all back together and I am very pleased with it so far after the big 10 to 15 minute ride
Well, I was covered in grease and tired, but I must say, the drive line feels alot firmer now. At 45 MPH I am running 1400 RPMS, and at 55 with out going any faster, I am running at 1600 RPMS. It has more of a truck feel to it now, because the engine is working at much lower RPMS. I was just wondering how low in RPMS it is safe to run this engine at, you have to factor in lower oil pressure and hammering the rod bearings, but I guess it should be OK, because it is in a very light load at 1400 RPM. I always try to keep my Cummins at 1600 RPM minimum. GDE had a very good write up for the TC change procedure, although I added a short cut, and had a set back. I skipped removing the fan blade to allow access to the flywheel bolt and turned the engine at the flywheel starter gear with a screwdriver. The set back was, the tab to the tranny dip stick that is bolted the to the upper bolt got stuck between the engine and tranny bell housing I did not know this until most of the bolts were snugged, in the future I would put the dip stick tube back in after the tranny is bolted back to the engine. I will give more updates after I drive the Jeep for a while.
Login
Register
FAQ
Search
