LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
U code!!!!!!! http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=54030 |
Page 1 of 1 |
Author: | toyota jeep man [ Mon Jul 05, 2010 10:43 am ] |
Post subject: | U code!!!!!!! |
my crd has been putting the mil on and then truning it off within after about one drive cycle and then it stayed on and i had jeep tell what is going on and they sayed it was a skim malfuntion so i bought a new rock key and had them programe it and it still comes on and off and now there is a U0146- Lost Communication With Gateway "A"!!!1 any one have any advise with any exsperince with this?! |
Author: | linewarbr [ Tue Jul 06, 2010 9:12 am ] |
Post subject: | Re: U code!!!!!!! |
Try posting in the regular "CRD. . . Love That Torque" section, you will get more response there. This section is for technical write-ups only. |
Author: | DynoPax [ Thu Jul 08, 2010 9:13 am ] |
Post subject: | Re: U code!!!!!!! |
I had the same code appear, in conjunction with P0146 & U0121, last week, at multiple intervals. On 2 or 3 occasions, the cluster would lite up like a x-mas tree, with sentry failure, water-in-fuel, ABS, ESP and CEL. It also meant instant limp mode and a dead cluster while driving. I was quite perplexed, especially in regard to the absence of logic behind these failures, after doing some research on the codes' meaning... O2 sensor bank 1 sensor 3 ??????? ![]() I have checked the cabling for ECM and ABS control module and since then, no more freak alerts! Bad/dirty/shorted connections? I'm keeping my eyes open for next occurence... |
Author: | toyota jeep man [ Fri Jul 09, 2010 3:30 am ] |
Post subject: | Re: U code!!!!!!! |
well from what i understand the 05 and the 06 have differint on board diaginosis the 05 witch i have has a combo of can bus and pci bus and there is a fcm (front controll module) wich commuicats with the 2 because they are diffeint speeds and the 06 has just the can bus and dose not have the problem that i am having.....and did not know if any one has had any exsprnce with this dam fcm?! ![]() |
Author: | boilermaker2 [ Fri Jul 09, 2010 11:08 am ] |
Post subject: | Re: U code!!!!!!! |
My dash freaked out a couple of times when I had a cell go bad in my red-top. Starting with the simplest first, you may want to take your battery to the part store of choice and have them test it under a load... Good luck, Boilermaker2 |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |