my crd has been putting the mil on and then truning it off within after about one drive cycle and then it stayed on and i had jeep tell what is going on and they sayed it was a skim malfuntion so i bought a new rock key and had them programe it and it still comes on and off and now there is a U0146- Lost Communication With Gateway "A"!!!1 any one have any advise with any exsperince with this?!

_________________
05 crd, old man emu, jeepin by al upper control arms, spider track wheel spacers, bf mud terrain t/a, full 3'' with a magnaflow exhaust,rocky road super sliders,skid row gas tank cover,surco roof rack with hella 500 lights,front hooks,b&m trans cooler!

Try posting in the regular "CRD. . . Love That Torque" section, you will get more response there. This section is for technical write-ups only.

_________________
In this war of lines, so many have been crossed. Where will it all stop?

2006 Deep Beryl Green CRD Sport *SOLD 1/22/12*
Provent, V6 Airbox, Fumoto, Samcos, GDE ECO & TCM Tune, Euro JK TC, Magnaflow Catback
245/70/16 Destination A/T's
Boiler's Radiator Skid Plate
Jeepin' By Al 2.5 inch Adjust-A-Strut Lift, JBA Gen 4.5 UCA's (6/5/10)

I had the same code appear, in conjunction with P0146 & U0121, last week, at multiple intervals. On 2 or 3 occasions, the cluster would lite up like a x-mas tree, with sentry failure, water-in-fuel, ABS, ESP and CEL. It also meant instant limp mode and a dead cluster while driving. I was quite perplexed, especially in regard to the absence of logic behind these failures, after doing some research on the codes' meaning... O2 sensor bank 1 sensor 3 ???????

I have checked the cabling for ECM and ABS control module and since then, no more freak alerts! Bad/dirty/shorted connections? I'm keeping my eyes open for next occurence...

_________________
RIP 10/31/2012
Green Metallic 2006 CRD Limited
GDE Hot tune ~ Pre-F37 TCM ~ Transgo shift kit ~ MagnaFlow ~ Homemade Provent ~ OME 2" lift & Airlift ~ Samco ~ Euro TC ~ Lift pump ~ Nylon fan blade & Hayden clutch ~ Etc!

well from what i understand the 05 and the 06 have differint on board diaginosis the 05 witch i have has a combo of can bus and pci bus and there is a fcm (front controll module) wich commuicats with the 2 because they are diffeint speeds and the 06 has just the can bus and dose not have the problem that i am having.....and did not know if any one has had any exsprnce with this dam fcm?!

_________________
05 crd, old man emu, jeepin by al upper control arms, spider track wheel spacers, bf mud terrain t/a, full 3'' with a magnaflow exhaust,rocky road super sliders,skid row gas tank cover,surco roof rack with hella 500 lights,front hooks,b&m trans cooler!

My dash freaked out a couple of times when I had a cell go bad in my red-top. Starting with the simplest first, you may want to take your battery to the part store of choice and have them test it under a load...
Good luck,
Boilermaker2

_________________
2005 CRD Sport - "Blackie"
Tow Package
Trac Loc
GDE EcoTune w/ unl torque
Goodyear Wrangler SilentArmor Tires
over 192,000+ miles
100k mile service performed
5V Glow Plugs Installed and ECM updated