What did you do to your CRD today?

LibertyCRD · **Posted:** Wed Jan 19, 2011 8:30 pm

Still enjoying my new GDE TCM tune. :BANANA:

Today I finished putting in my new Husky floor liners. Got the front and rear for $120 shipped!

flman · **Posted:** Fri Jan 21, 2011 1:42 pm

4 New Terra Tracs on the Sport $$$$$ Cha Ching $$$$$

METCRD · **Posted:** Fri Jan 21, 2011 6:08 pm

Emissions check then ORM. Can't wait to really go for a drive.

benzer · **Posted:** Sun Jan 23, 2011 4:09 pm

Replaced the thermostat and gasket. Only a little over
two gallons of old coolant out. Filled her up with Zerex G05
and distilled water. Temp gauge is now just to the left of 12:00.

Loving that cabin heat!!!! 16 F here for a high today!!!

The mileage on the EVIC went up about three MPG's almost
immediately after installing the new stat. I know the EVIC is not
accurate, but it's still got to be better than it was!!!!

John

Quiksilver · **Posted:** Mon Jan 24, 2011 1:41 pm

New Fan clutch installed .. been driving around in scorching weather with AC on full. Needle is sitting where its meant to for first time in ages - even idling in heavy traffic. :JEEPIN:

JeepBumm68 · **Posted:** Tue Jan 25, 2011 12:11 am

Got the Front D44 Truss in today, The rear BTF D60 Truss in, The BTF Rear Coils buckets. Now time to start tacking it on once all measurements all done. Then get the front and rear brackets/tabs made up for the coilovers

racertracer · **Posted:** Tue Jan 25, 2011 9:22 am

JeepBumm68 wrote:

Got the Front D44 Truss in today, The rear BTF D60 Truss in, The BTF Rear Coils buckets. Now time to start tacking it on once all measurements all done. Then get the front and rear brackets/tabs made up for the coilovers

And your performing this work on your CRD?

JeepBumm68 · **Posted:** Tue Jan 25, 2011 11:35 am

Yep, already have it SFA'd, just getting rid tj d30/d44 combo and putting in the FW's.

UFO · **Posted:** Wed Jan 26, 2011 7:14 pm

JeepBumm68 wrote:

Got the Front D44 Truss in today, The rear BTF D60 Truss in, The BTF Rear Coils buckets. Now time to start tacking it on once all measurements all done. Then get the front and rear brackets/tabs made up for the coilovers

Oh, I want to see this!!! :pepper:

flman · **Posted:** Wed Jan 26, 2011 8:32 pm

New Lift cylinders on the rear window of the Sport = spend more money

Quiksilver · **Posted:** Thu Jan 27, 2011 7:04 am

BlackLiberty Style under bonnet lift pump installed :mrgreen:

audiboy86 · **Posted:** Fri Jan 28, 2011 12:52 am

GDE TCM tune install and getting use to this new shift pattern. I got about 500+ miles to drive tomorrow to break it in. Going to visit our nations capital so let it snow let it snow.

mungewell · **Joined:** Tue Jan 11, 2011 6:04 pm **Posts:** 48

Clean MAP sensor, tightened 'Water in Fuel' drain as it appears to be the cause of 'Air in Fuel' problems since I change fuel filter last week - hopefully that's fixed now.

Simon.

woodtick · **Posted:** Mon Jan 31, 2011 10:47 pm

Well Saturday I installed racor lift pump in line. Job was easy took more time to find all the tools than to do the work. Took pics and will post soon.

So far seem to have less crank time before firing on cold start

( temps lows around 10). Also, seems to not have rpm wander at 40 mph cruise control like before

. Have not noticed shorter turbo lag as some have stated

. Going to recheck for air @ fuel head.

Will post more as results warrant.

METCRD · **Posted:** Mon Jan 31, 2011 11:10 pm

Last night I couldn't wait any longer and put on my stealth decals using a hair dryer to warm up the glass....also to warm up the glass cleaner on the glass in order to install them. I got the full set and they look SWEET!!! :lol:

audiboy86 · **Posted:** Tue Feb 01, 2011 11:24 am

Oil changed yesterday after my trip using the new to me Mobil One Diesel Truck oil i have never seen it before and it meets all the standards so i am going to try it and see how it compares to Royal Purple. Also still breaking in the new TCM in tune seems to be meshing well with my lift and tires jsut had to change up my driving style a bit.

JeepBumm68 · **Posted:** Tue Feb 01, 2011 12:11 pm

got the coil bucket brackets in, all the tabs, and now waiting for it to warm up to do some grinding and welding on the axles lol.

arengant · **Posted:** Sat Feb 05, 2011 9:03 pm

Installed the power/leather seats out of another '05, but have to figure out the wiring for the heat...

Had to swap the air bag/bladder sensor from the stock sport seat to the new seats, but besides that a really sweet install!

flman · **Posted:** Mon Feb 14, 2011 7:46 pm

Washed both of them today!

Well, just a pressure wash at 2300 PSI, but they look a hell of alot better.

arengant · **Posted:** Fri Feb 18, 2011 2:56 pm

Ordered gas tank and radiator skids from Boiler!

Sweet...

What did you do to your CRD today?

Who is online