I have a 2005 CRD and I need to add two more remotes for locking/unlocking the doors. I have only one working remote/key that came with the jeep. I followed the procedure for adding remotes in the owners manual page 28 "to program additional transmitters" but could never get into the "program mode".

All of the buttons on the working remote respond correctly when depressed individually.

To get into programming mode I depress and hold the unlock button for 6 seconds then I press the panic button then release both at the same time. I get no conformation tone indicating I went into programming mode. I then attempted to program each new transmitter by pressing ("lock and unlock" simultaneously and pressing any button), but I get no conformation tone and the remotes do not function. When I attempt to reprogram the working key it just unlocks/locks the doors acting like it never went into program mode?

I would really hate to take it to the dealer for a problem like this.

What am I doing wrong? Has anyone else had this problem? Is this a CRD only issue?

Just for added information I was able to successfully add a third transponder key with no remote using the procedure in the owners manual.

Welcome the the forum, but this is the section for technical write ups. Please post in the Liberty CRD...Love that Torque!!! and you will be more likely to get a response.

Thanks click23, looks like I did not read the introduction clearly enough. I will copy the post to the correct section.