warp2diesel wrote:
Try to pump the primer and crack open the bleeder valve?
Lift pump is the cure.
Lift pump is the cure.
Thanks, I'll give that a shot.
John
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Running Bad!!! http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=57216 |
Page 1 of 1 |
| Author: | benzer [ Mon Nov 29, 2010 7:18 pm ] |
| Post subject: | Running Bad!!! |
Hi Guys, On the way home from work, the CRD started running terrible. I wonder if there is air getting into the fuel lines since I just replaced the fuel filter. It runs as if the EGR is stuck open. It shakes bad and has no power, no CEL though........... Ideas? Thanks, John |
|
| Author: | warp2diesel [ Mon Nov 29, 2010 7:30 pm ] |
| Post subject: | Re: Running Bad!!! |
Try to pump the primer and crack open the bleeder valve? Lift pump is the cure. |
|
| Author: | benzer [ Mon Nov 29, 2010 7:33 pm ] |
| Post subject: | Re: Running Bad!!! |
warp2diesel wrote: Try to pump the primer and crack open the bleeder valve? Lift pump is the cure. Thanks, I'll give that a shot. John |
|
| Author: | benzer [ Mon Nov 29, 2010 8:02 pm ] |
| Post subject: | Re: Running Bad!!! |
warp2diesel wrote: Try to pump the primer and crack open the bleeder valve? Lift pump is the cure. Thanks again warp2diesel, There was air in the system. I think it was my error, I did not tighten the filter enough when I put the new one on. I have the tendency to over-tighten things, so I was trying to be careful. Tonight I turned it gently with the filter wrench, about 1/2 to 3/4 of a turn, it's snug now. John |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|