I purchased a SEGR kit from LocoCRD can't seem to get a hold of him for better installation instructions. Has anyone purchased a non assembled non soldered kit?? The instructions are confusing and don't take into account that the end user is novice. Any ideas..links or photos, thanks in advance for the help.jeff

I once purchased an assembled one, then I heard about GDE Tune and I sold it instead of splicing into my ECM wiring.

_________________
2006 LTD Bright Silver loaded with all the needed mods, CCV intact.
Proudly supporting CRD vendors, and their development of quality parts and accessories.
Equipped with HDS thermostat, plenty of heat, faster warm-ups, increased fuel mileage.

I'm glad you mentioned the GDE Tune, I spoke with their competitor and was going to get their tune, and they said the the SEGR was still needed as the GDE tune does not truly illuminate the EGR,?? I'm not worried about the splicing its the wiring from the SEGR to the harness I don't understand

Try UFO. I think he used to build them.

_________________
2006 CRD Limited Dk Khaki
InMotion S-II, GDE TCM, Cummins Lift Pump, Mishimoto CAC hoses
Cooper Discoverer ATP LT245/75, Rola roof basket, JCR S3 sliders
OME lift+JBA UCA's, custom front hitch receiver, Mile Marker winch
All J Products rear cargo shelf
Sips biodiesel as if it were 12 y/o Scotch

If you have never soldered a board together contact UFO and pay him to do it. Save yourself alot of grief!

_________________
06 LIMITED 100000miles, MAGNAFLOW, HOMEBUILT CCV FILTER, POLAR PAD, 02 AIRBOX, CUMMINS LIFT PUMP, SEGR, PILLAR GAUGE POD, CAT FILTER MONITOR, SPYDER TRAX, ALWAYS A LITTLE TWO STROKE OIL OR BIO, WATER/METH INJECTION