| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| 12V power source http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=58817 |
Page 1 of 1 |
| Author: | weantright [ Wed Feb 09, 2011 9:13 am ] |
| Post subject: | 12V power source |
I am installing heated seats covers and looking to find a 12v power source. It need to be activated with the key (forgot to unplug and killed the battery). Where is a good spot??? |
|
| Author: | Joe Romas [ Wed Feb 09, 2011 9:49 am ] |
| Post subject: | Re: 12V power source |
I would tie into the trailer towing fuse on the driver's side fuse panel to pick a relay for your seats, it's a switched voltage. Then in the fuse panel by the battery hook into the trailer tow for the power to the seats. that way your seats can't mess with something else 
|
|
| Author: | JL Rockies [ Wed Feb 09, 2011 11:16 am ] |
| Post subject: | Re: 12V power source |
This really isn't a CRD specific question. |
|
| Author: | Drewd [ Sat Feb 12, 2011 11:57 pm ] |
| Post subject: | Re: 12V power source |
True, but most of us here never visit any other forum section and prefer the advice of our CRD brethren. |
|
| Author: | dgeist [ Sun Feb 13, 2011 9:47 am ] |
| Post subject: | Re: 12V power source |
Post forum location aside, have you checked the manuals to see how the ones on the limited are powered? There's probably a wiring harness that just needs a fuse installed to make it work. Dan |
|
| Author: | Sir Sam [ Sun Feb 13, 2011 3:23 pm ] |
| Post subject: | Re: 12V power source |
dgeist wrote: Post forum location aside, have you checked the manuals to see how the ones on the limited are powered? There's probably a wiring harness that just needs a fuse installed to make it work. Dan This is a dead end, the cavity for the factory power seats cannot simply have a fuse added to activate that circuit. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|