LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Magnaflow cat back arrives, now for needed changes
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=58836		 Page 1 of 1
Author:  jeepdan [ Thu Feb 10, 2011 2:36 pm ]
Post subject:  Magnaflow cat back arrives, now for needed changes
With 5 1/2 winters of corrosive salt :furious: I decided to buy the the complete cat back system to upgrade the exhaust this spring. The Magnaflow muffler inlet flange is necked down to a 2 1/8 I.D. :evil: I was hoping to only have to open up the cat side of the flange the way Warp did his. Magnaflow does sell a stainless 2 1/2" ball flange kit but at a cost of $99.00. I may go that route as I would like to keep it factory looking.
Author:  Joe Romas [ Thu Feb 10, 2011 3:37 pm ]
Post subject:  Re: Magnaflow cat back arrives, now for needed changes
I'm thinking of doing the same and have found this flow master at Jeg's, local to me, for $72.99 but they don't list the material and I suspect it's not SS.
http://www.jegs.com/i/Flowmaster/389/15 ... tId=752165
I think I'll just need to get on over to Jeg's :JEEPIN:
Author:  warp2diesel [ Fri Feb 11, 2011 2:25 pm ]
Post subject:  Re: Magnaflow cat back arrives, now for needed changes
Open it up, no one is going to crawl under your CRD and look.
After a few months, no one can tell I modified my flange.
Let Sir Isac Newton rest in peace.
After all, it is fun to blow away the Crossover gassers when you pull away from the stop light.
Author:  salden77 [ Fri Feb 11, 2011 4:00 pm ]
Post subject:  Re: Magnaflow cat back arrives, now for needed changes
i took my cat completely out and straight piped the exhaust, sounds mean
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/