Doesn't matter, a heater is a heater and there's no polerization (sp?) just make sure your splicing in to the heater and not the sensor
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Help with new fuel head http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=59430 |
Page 1 of 1 |
| Author: | LibertyCRD [ Sat Mar 12, 2011 9:14 am ] |
| Post subject: | Help with new fuel head |
I'm installing a new fuel filter head and included wiring right now...but there are NO instructions included and I don't know which wires to splice to which! The old heater plug has red/black. The new one has purple/green. What goes with what?? |
|
| Author: | Joe Romas [ Sat Mar 12, 2011 9:19 am ] |
| Post subject: | Re: Help with new fuel head |
Doesn't matter, a heater is a heater and there's no polerization (sp?) just make sure your splicing in to the heater and not the sensor
|
|
| Author: | racertracer [ Sat Mar 12, 2011 9:33 am ] |
| Post subject: | Re: Help with new fuel head |
Match the thickness of the wires, don't go by color. If you try to match color, it will drive you nuts. The factory wire assembly people must have been on some psychedelic drug that day because no two wire assemblies have the same color wire. So match the thickness of the wires instead of color and you’ll be fine, that's how most of us did it and it works. |
|
| Author: | papaindigo [ Sat Mar 12, 2011 1:06 pm ] |
| Post subject: | Re: Help with new fuel head |
See picture at the bottom of http://www.greendieselengineering.com/f ... st/76.page It's how stoutdog and I wired our new filter heads in January 2010, no problems since. |
|
| Author: | LibertyCRD [ Sat Mar 12, 2011 8:13 pm ] |
| Post subject: | Re: Help with new fuel head |
Ok thanks. Got that job done. It wasn't too bad. Now, the timing belt and water pump and the new CV shaft/intermediate shaft on the other hand....that was a total nightmare. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|