| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Transmission Shifting http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=60376 |
Page 1 of 1 |
| Author: | Houghton [ Tue Apr 26, 2011 12:15 pm ] |
| Post subject: | Transmission Shifting |
Hello I am new to this I hope I am doing this right. I have a 2005 CRD limited with 65000 miles on it, all stock. About a week ago it started shifting from 2 to 3 hard like it would throw you through the windsheld. It only does it when shifting up, but when i turn the overdrive off it won't do it. Could it be my torque converter? Any suggetions? Thanks James |
|
| Author: | Joe Romas [ Tue Apr 26, 2011 12:42 pm ] |
| Post subject: | Re: Transmission Shifting |
Read the noob guide and look for the link where you can download the FSM (that stands for Factory Service Manual). With that go to the CRD TECH section and look for the thread on doing a "Quick Learn" and look at the pages in the FSM I have listed. DON'T POST IN THAT SECTION  Then find the procedure that covers the second to third upshift  Your TCM (transmission control module) is intelegent or maybe just dumb, anyway it needs to "learn" 
|
|
| Author: | Houghton [ Thu Apr 28, 2011 11:47 am ] |
| Post subject: | Re: Transmission Shifting |
Hey Joe thanks for the help! I found what you where talking about in the manual, but it is real confusing. Do I need a scan tool to do this or can I just disconect the battery? Thanks James |
|
| Author: | Joe Romas [ Thu Apr 28, 2011 4:00 pm ] |
| Post subject: | Re: Transmission Shifting |
Houghton wrote: Hey Joe thanks for the help! I found what you where talking about in the manual, but it is real confusing. Do I need a scan tool to do this or can I just disconect the battery? Thanks James James. Here's the thread and flman replied with instructions. No scantool is needed. viewtopic.php?f=98&t=49854 |
|
| Author: | Houghton [ Wed May 04, 2011 12:50 pm ] |
| Post subject: | Re: Transmission Shifting |
Thanks again Joe, I tried the Quick Learn, and it didn't help. Any other suggestions? Looks like i might have to take it to the stealership! 
|
|
| Author: | papaindigo [ Wed May 04, 2011 3:03 pm ] |
| Post subject: | Re: Transmission Shifting |
You did check fluid level? Pretty obvious but since it's not mentioned I feel compelled to ask. |
|
| Author: | Houghton [ Wed May 04, 2011 3:39 pm ] |
| Post subject: | Re: Transmission Shifting |
I did, and I was hoping it was that simple, but my luck its not. Thanks |
|
| Author: | Rabert [ Wed May 04, 2011 4:34 pm ] |
| Post subject: | Re: Transmission Shifting |
Checkout this thread. I had a similar issue after doing the ORM and FLCV. I could clear the codes but it would creep back up. I "backed out" the FLCV mod and ORM. took TCM and ECM connectors off/cleaned/inspected/installed, covered bare wires by EGR with split heater hose and viagra I was up and running, the jeep that is....anyway I've got the ORM mod back in place, keeping my fingers crossed. viewtopic.php?f=5&t=59945 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|