| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Euro Torque Converter http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=60392 |
Page 1 of 1 |
| Author: | wfd1350 [ Wed Apr 27, 2011 12:34 am ] |
| Post subject: | Euro Torque Converter |
Almost finished installing a Euro TC when my buddy noticed an rubber o-ring on the shaft of the old TC. I didn't notice if the Euro converter had an o-ring or not. Now I'm afraid that I may have to pull the newly installed TC because I'm unsure if it had an o-ring... not even sure if it needs one. Anyone know? Thanks |
|
| Author: | Lancer [ Wed Apr 27, 2011 5:29 am ] |
| Post subject: | Re: Euro Torque Converter |
Sorry, I don't know, but perhaps an email to Keith at GDE? |
|
| Author: | salden77 [ Wed Apr 27, 2011 6:31 am ] |
| Post subject: | Re: Euro Torque Converter |
wfd1350 wrote: Almost finished installing a Euro TC when my buddy noticed an rubber o-ring on the shaft of the old TC. I didn't notice if the Euro converter had an o-ring or not. Now I'm afraid that I may have to pull the newly installed TC because I'm unsure if it had an o-ring... not even sure if it needs one. Anyone know? Thanks any update on the o ring? i have my new TC just waiting till i have time to put it in. |
|
| Author: | flman [ Wed Apr 27, 2011 6:44 am ] |
| Post subject: | Re: Euro Torque Converter |
You don't need an O Ring, there is a seal inside of the front pump. O rings on not designed for use on spinning objects. Was it on the engine side, or the tranny side? |
|
| Author: | wfd1350 [ Wed Apr 27, 2011 10:08 am ] |
| Post subject: | Re: Euro Torque Converter |
The rubber o-ring was on the transmission side of the TC. |
|
| Author: | CATCRD [ Wed Apr 27, 2011 8:29 pm ] |
| Post subject: | Re: Euro Torque Converter |
wfd1350 wrote: Almost finished installing a Euro TC when my buddy noticed an rubber o-ring on the shaft of the old TC. I didn't notice if the Euro converter had an o-ring or not. Now I'm afraid that I may have to pull the newly installed TC because I'm unsure if it had an o-ring... not even sure if it needs one. Anyone know? Thanks Yes, there should be an o-ring on the splined shaft you slide into the tranny. I made darn sure mine was on there when I put it in. |
|
| Author: | GreenDieselEngineering [ Wed Apr 27, 2011 10:14 pm ] |
| Post subject: | Re: Euro Torque Converter |
Our stock TCs still had the orings installed, so it was most likely there and you did not notice. Fairly confident the euro TC came with an oring. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|