Welcome to LOST
Since this is not a CRD specific problem you may have better results in the general section.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rear Caliper Support bolts tourqe? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=62417 |
Page 1 of 1 |
| Author: | chipster [ Sun Sep 04, 2011 11:32 am ] |
| Post subject: | Rear Caliper Support bolts tourqe? |
I have to replace the rivets on the rear parking brake support of a 2006 CRD Limited. In order to clean out the old rivets i had to loosen the caliper support nuts (in addition to pulling the axle shaft) so I could push the rivet through. Does anyone know the torque specs for the caliper support nuts? The service manual says to tighten the front caliper support nuts to 135NM (100 ft.lbs) on page 5-24 but it doesn't mention anything about the rear caliper support. Also, does anyone know what size rivets are used with the parking brake support? This is a horrible design. |
|
| Author: | Joe Romas [ Sun Sep 04, 2011 11:53 am ] |
| Post subject: | Re: Rear Caliper Support bolts tourqe? |
Welcome to LOST Since this is not a CRD specific problem you may have better results in the general section. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|