| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Water in the filter http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=64713 |
Page 1 of 1 |
| Author: | JeepsRule [ Mon Jan 16, 2012 8:42 am ] |
| Post subject: | Water in the filter |
Can you drain water out of the fuel/water separator or does one need to replace the filter? The warning light is going on when cold. Once it warms up the light is out. |
|
| Author: | papaindigo [ Mon Jan 16, 2012 10:49 am ] |
| Post subject: | Re: Water in the filter |
In theory you can drain the water but the CRD filter is not like the ones I had on my Dodge Cummins where there was a drain tube and pull tab attached to the sensor (pull the tab; water/diesel drain down tube on ground or a container if you put one there; push tab back up). On the CRD you have to undo the sensor wire and unscrew the sensor from the bottom of the filter which of course dumps the entire filter contents. If it was me and because the easiest way to get to that sensor is to remove the entire filter head and filter from the firewall I'd just bit the bullet and replace the filter (WIX 33647 or equivalent). However, if you have a 1st gen filter head (see fuel head bleeding video on Sam's NOOB guide for picture of the difference) I'd strongly recommend getting a 2n gen head (comes with filter and WIF sensor installed) + the wiring pigtail and install it. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|