I LOVE LAMP
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Not Too Bad a Job http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=69332 |
Page 1 of 1 |
| Author: | fastRob [ Sun Jun 24, 2012 5:33 pm ] |
| Post subject: | Not Too Bad a Job |
1.5-2 hours The torx fastener is the real important part plus rust solvent. Stringing the wires for the sensors was a pin. |
|
| Author: | Sir Sam [ Sun Jun 24, 2012 5:59 pm ] |
| Post subject: | Re: Not Too Bad a Job |
I LOVE LAMP
|
|
| Author: | racertracer [ Sun Jun 24, 2012 6:53 pm ] |
| Post subject: | Re: Not Too Bad a Job |
Ok... what ? |
|
| Author: | bugnout [ Sun Jun 24, 2012 7:48 pm ] |
| Post subject: | Re: Not Too Bad a Job |
He replaced a bearing hub. The Torx reference gives it away 
|
|
| Author: | user113 [ Mon Jun 25, 2012 1:44 am ] |
| Post subject: | Re: Not Too Bad a Job |
Really? I wish I was psychic like that. |
|
| Author: | fastRob [ Thu Jun 28, 2012 12:08 pm ] |
| Post subject: | Re: Not Too Bad a Job |
Sorry, viewtopic.php?f=5&t=69316 Clarity was never a strength. About wheel bearing replacement. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|