| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| liberty wont move http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=73030 |
Page 1 of 1 |
| Author: | toroos [ Thu Dec 27, 2012 5:52 pm ] |
| Post subject: | liberty wont move |
OK I am driving along at 75 and go to pass somebody and the rpms shot up to 4k and it was accelerating anymore. I pull off the highway and have no movement anymore. the fluid is clean and the only noise I hear is a slight whine. Anybody have any ideas what it could be? |
|
| Author: | LMWatBullRun [ Thu Dec 27, 2012 6:01 pm ] |
| Post subject: | Re: liberty wont move |
toroos wrote: OK I am driving along at 75 and go to pass somebody and the rpms shot up to 4k and it was accelerating anymore. I pull off the highway and have no movement anymore. the fluid is clean and the only noise I hear is a slight whine. Anybody have any ideas what it could be? Well, to state the obvious, something bad happened. I assume the fluid level is OK; lack of fluid will do that, like if you burst a hose and spewed fluid out. My first checks would be in order: U joints, Transfer case cable, Then it gets harder; Flexplate bolts, ( remove starter) After that it gets involved, and expensive. Maybe the TC hub, maybe something else. |
|
| Author: | Drewd [ Fri Dec 28, 2012 12:04 am ] |
| Post subject: | Re: liberty wont move |
After you rule out cable to the xfer case, I'd bet my mony on a blown torque converter. Good luck. To rule out u-joints looks under vehicle if a driveshaft is dragging on the ground, its u-joint. All of the other issues a previous poster mentioned (flex plate bolts, cables, etc.) can be determined as part of the process dropping the tranny for a TC replacement. |
|
| Author: | 2007mega [ Thu Jan 03, 2013 8:56 pm ] |
| Post subject: | Re: liberty wont move |
Mine did the same. Splines gone on torque converter |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|