i start my crd it fires up just fine turn if off try to start immediatly acts like it has no fuel so far ive changed fuel head and filter cam sensor i dont now what else to do its not throwing any codes there is absolutly no air in the lines any ideas??

Did you bleed the fuel filter?

edit: SORRY! I didn't read your whole message before saying that. Now we wait for people who know much more then I do to chime in...

_________________
Low mileage 2005 Jeep Liberty CRD for sale.

Ok...Not to be a smart A, but how do you know there is no air in the lines? Do you have a clear hose to look for bubbles? I installed one when i had a air in fuel problem. this is to be temp use only.

Air in fuel does not through a code. Be sure the filter is tight and was installed correctly with the provided seals? The old seals were removed correct? Sometimes the hose clamps cut into the hoses and lets air in. If you suspect? you can trim a inch off the hoses and reinstall them. Bleed bleed bleed.

_________________
05 Liberty CRD Sport with Leather 115k
GDE ECO, No EGR, no FCV, (system gone)
Oil Drain plug P/N 090-039
K&N Air Filter, 2nd gen Fuel filter head
NEW Rockers & lifters
Mobil 1 0w-40
Stant 13519 195 deg inline Thermostat.
0 281 002 845 MAP
Etecno GX3123 7v Glow Plugs
Advance Gold 800CCA Battery
Traded it for a Quality VW TDI

I second bleeding the heck out of it. Also dont tighten down the sensor on the bottom of the fuel filter to tight otherwise it can leak fuel passed the seal.

_________________
OME 2790/2948 Rancho all around
JBA strut plates with clevis lift
2 extra rear upper isolators and one extra lower
Front sits 23
Rear sits 22 3/4
265 75 16 Maxxis Big Horn MT
GDE Hot Tune
Bumper trimming up front

x3..... a lot of air is hard to get out.

_________________
2006 Liberty CRD Limited

Provent @ 43,000 km
SEGR in progress
SAMCO Sport hoses @ 48500 km
Goodyear Wrangler Duratrac LT225/75R16