| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Transmission codes 0700, 0733, 0734, 0735 http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=74713 |
Page 1 of 2 |
| Author: | racertracer [ Fri Mar 29, 2013 5:19 pm ] |
| Post subject: | Transmission codes 0700, 0733, 0734, 0735 |
The transmission has trouble shifting into the higher gears. Not sure what is happing with my transmission, anybody know what it is? |
|
| Author: | GreenDieselEngineering [ Fri Mar 29, 2013 6:17 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
733 incorrect gear 3 ratio 734 incorrect gear 4 ratio 735 incorrect gear 5 ratio I think your torque converter is toast. |
|
| Author: | racertracer [ Fri Mar 29, 2013 6:21 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Thanks Keith, I would like to have proof in hand .... How can I confirm that prior to bringing it back to the dealer? |
|
| Author: | GreenDieselEngineering [ Fri Mar 29, 2013 6:24 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Those codes all tend to point at a lock-up clutch that is not locking up. If the dealer pulls the codes and understands their product, then it should be fairly easy for them to determine the root cause. |
|
| Author: | racertracer [ Fri Mar 29, 2013 7:17 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Ok, I hope so.... But here is an update, I took the jeep out for a ride and when I returned I checked the codes again and only the 0700 code is showing, the other codes have gone away, will the dealer still be able to pull the codes? |
|
| Author: | Srytrucker [ Fri Mar 29, 2013 9:46 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
A busted pan filter was also causing some grief to fellow peeps here so worth a looksy before breaking the wallet. Shelby was having these codes for busted pan filter P0700 Transmission Control System P0731 Gear 1 Incorrect Ratio. |
|
| Author: | racertracer [ Tue Apr 02, 2013 2:29 am ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
OK, the Jeep is at the dealer for diagnosis. I'll report back. |
|
| Author: | racertracer [ Tue Apr 02, 2013 4:40 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Update: Dealer pulled the following codes: P0733 Gear ratio error in third. P0735 Gear ratio error in fourth prime. P0868 Line pressure low. P0869 Line pressure High. P0935 Line pressure sensor high. P1790 Fault immediate after shift. Transmission was worked on last June. TC was replaced, pump was replaced, intercooler and hoses were replaced. Transmission was disassembled and reassembled for some unknown reason. Warranty is in question Chrysler Customer care has been made aware of the issue and has assigned a case manager on it. Expecting a call tomorrow to find out if it will be repaired under warranty. |
|
| Author: | bentstrider83 [ Fri Apr 05, 2013 12:12 am ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
I've got the codes P0871 and P0750. Transmission doesn't seem to be shifting into higher gear. This happened right along the the Frontage road along the 40 when turning off of University in ABQ. Are these also signs of the TC about to bite it? |
|
| Author: | GreenDieselEngineering [ Fri Apr 05, 2013 6:23 am ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
bentstrider83 wrote: I've got the codes P0871 and P0750. Transmission doesn't seem to be shifting into higher gear. This happened right along the the Frontage road along the 40 when turning off of University in ABQ. Are these also signs of the TC about to bite it? P0750 - Shift solenoid "A" circuit issue P0871 - Trans fluid pressure sensor switch "C" performance or OD pressure rationality fault. Something electrical or a couple failed sensors. You need a shop to do some testing. |
|
| Author: | racertracer [ Fri Apr 05, 2013 6:49 am ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Chrysler customer care called and said " The transmission is no longer under warranty" and that the case is closed. I was not pleased with this answer so I asked that my case to be reconsidered and was assigned a new case manager who was not sure how to proceed, so I asked to speak to a supervisor. The supervisor was understanding and believed that the Transmission could still be under the original F37 recall warranty or maybe even the 7/70 since the vehicle only has 56,000 miles on it. She assigned a new case manager to take over. A new case manager informed me that further investigative work will need to be done and to expect a response in 5 days. |
|
| Author: | bentstrider83 [ Mon Apr 08, 2013 8:27 am ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
GreenDieselEngineering wrote: bentstrider83 wrote: I've got the codes P0871 and P0750. Transmission doesn't seem to be shifting into higher gear. This happened right along the the Frontage road along the 40 when turning off of University in ABQ. Are these also signs of the TC about to bite it? P0750 - Shift solenoid "A" circuit issue P0871 - Trans fluid pressure sensor switch "C" performance or OD pressure rationality fault. Something electrical or a couple failed sensors. You need a shop to do some testing. I just upped and took it to a place in Lubbock. I bought it with an extended service option that covered things like this, so we'll bite the bullet and see what happens. |
|
| Author: | racertracer [ Tue May 07, 2013 7:09 am ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
The jeep is still at the dealer, 5 weeks now. They haven't determined what the problem is yet and the transmission has been torn apart 3 times. To this day, this transmission has had 5 TC replaced within 14 months all under the direction of Chrysler customer care. 1 factory tc replaced with 1 at F37 update. 2 TC replaced last year after 2nd TC failed. 1 TC recently swapped. I feel that a new transmission would be the best way to repair this problem and I have voiced this to Chrysler. |
|
| Author: | racertracer [ Thu May 16, 2013 9:17 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Dealer said that a brand new Transmission with a new TC and Pump pre installed at the factory is on its way to him now and will be installed in my CRD as soon as it gets there. Woo Hoo. |
|
| Author: | racertracer [ Mon May 27, 2013 9:16 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Transmission is installed and shifts perfect, but I have a constant chirping noise coming from the bell housing area when I am stopped and the transmission is in drive or reverse. The noise goes away when it is in neutral or Park. The chirping is pretty loud. Any ideas? |
|
| Author: | DOC4444 [ Mon May 27, 2013 10:03 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
DON'T JUMP! DOC |
|
| Author: | racertracer [ Tue May 28, 2013 3:02 am ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
DOC4444 wrote: DON'T JUMP! DOC What? |
|
| Author: | CATCRD [ Thu May 30, 2013 2:18 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Like...off a bridge. |
|
| Author: | Hexus [ Thu May 30, 2013 3:14 pm ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Take it back to the dealer now and get it fixed, again. That's what he was saying. Properly rebuilt/adjusted/new transmissions do not "CHIRP." |
|
| Author: | racertracer [ Thu Jun 13, 2013 6:23 am ] |
| Post subject: | Re: Transmission codes 0700, 0733, 0734, 0735 |
Update: The dealer took care of the problem. The transmission shifts smooth and the noise is gone, but I still have an harmonic wobble / shake that is felt while traveling at sustained speeds of 60 MPH and above. I called Chrysler customer care again to tell them about the issue and the representative directed me to take it back to the dealer and have it checked out again. I have to say that I am very happy with the way I have been treated by Chrysler customer care, they have been diligently working with me to fix these issues. The representatives' exact words were the following "Sir, we plan to make things right with the vehicle, what ever it takes. We want you to be happy with your vehicle." I don't know what changed but it sounds a little different than what the rep was saying on previous occasions, when the only words I heard were "sorry sir, there is nothing we can do for you." |
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|