| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Cruise control switches....Programming? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=74776 |
Page 1 of 1 |
| Author: | Oilburner44 [ Tue Apr 02, 2013 8:55 pm ] |
| Post subject: | Cruise control switches....Programming? |
So i bought used radio and cruise control switches. and installed them on my jeep. Thee jeep did not previously have cruise or radio switches. I plugged in the new wiring harness and hooked up everything. The radio switches work but the cruise does not. I have checked switches with a volt meter and they appear to be working. Do i need to bring the jeep to the dealer to enable it to work? I dont even get the light on the dash for cruise let alone it actually working. Not sure what to do, hope someone on here can help. |
|
| Author: | CATCRD [ Tue Apr 02, 2013 9:07 pm ] |
| Post subject: | Re: Cruise control switches....Programming? |
Yes, you need to take it to a dealer or find someone local with a DRBIII. That's what I had done after installing junkyard switches. |
|
| Author: | MrMopar64 [ Tue Apr 02, 2013 9:45 pm ] |
| Post subject: | Re: Cruise control switches....Programming? |
With DRBIII, you have to reset the cruise switch learning. Then you have to continue holding the on/off position until the "CRUISE" lights up in the cluster. 5minutes max, takes longer to turn on the DRBIII than it does to do the procedure. |
|
| Author: | Dennis MacGyver [ Wed Apr 03, 2013 1:27 am ] |
| Post subject: | Re: Cruise control switches....Programming? |
Does the vehicle have the remote locking feature ? If so, this indicates that the "BCM" is present (body control module). Some of the lower priced Liberty's did not have this module . More than you ver wanted to know in the below thread. viewtopic.php?f=98&t=37173 |
|
| Author: | Oilburner44 [ Thu Apr 04, 2013 5:10 am ] |
| Post subject: | Re: Cruise control switches....Programming? |
Thanks guys!!! Looks like i gotta pay the dealer to enable it. I tried tonight with a snap-pn modus just to see what i could do with the crd computer. No such luck, for anyone curiouse. |
|
| Author: | GreenDieselEngineering [ Thu Apr 04, 2013 6:14 am ] |
| Post subject: | Re: Cruise control switches....Programming? |
We can also reset the CC if you ship the ecm in for tuning. Of course the tune is more than the dealer, but pays for itself in fuel savings. |
|
| Author: | papaindigo [ Thu Apr 04, 2013 7:54 am ] |
| Post subject: | Re: Cruise control switches....Programming? |
Just to add to GDE's comment. It's likely that a dealer, you can call and check, will charge you on the order of $100 to turn the cruise on in your ECU so if you go directly to GDE that's $100 you won't have to pay the dealer which can go toward the GDE tune. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|