LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Rebuild front drive shaft, too late? Same as gas jeep?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=74836
Page 1 of 1

Author:  painemann [ Mon Apr 08, 2013 9:43 am ]
Post subject:  Rebuild front drive shaft, too late? Same as gas jeep?

Well my front drive shaft is wasted and removed and wondering if it is too wasted for a rebuild kit?
Anyone know of any writeups on the rebuild?
Are the CRD driveshafts the same as a gas jeep?
Image

Author:  Billy M [ Mon Apr 08, 2013 12:07 pm ]
Post subject:  Re: Rebuild front drive shaft, too late? Same as gas jeep?

Pack it full of grease and put it back in! :-)r

I personally would replace that. That's pretty bad.

Billy

Author:  painemann [ Mon Apr 08, 2013 12:10 pm ]
Post subject:  Re: Rebuild front drive shaft, too late? Same as gas jeep?

Billy M wrote:
Pack it full of grease and put it back in! :-)r

I personally would replace that. That's pretty bad.

Billy



was thinking this...
http://www.driveshaftparts.com/cv-joints-shafts/jeep-front-driveshaft-cv-joint/prod_430.html

Author:  Billy M [ Mon Apr 08, 2013 12:28 pm ]
Post subject:  Re: Rebuild front drive shaft, too late? Same as gas jeep?

That looks pretty simple/straight forward. I haven't fooled with one on the Jeep, but it looks like a simple CV assembly on a splined shaft. Looks like an easy fix. Price is right too. I would do it as long as the splines are fine on the axle.

Billy

Author:  ibedonc [ Mon Apr 08, 2013 3:10 pm ]
Post subject:  Re: Rebuild front drive shaft, too late? Same as gas jeep?

painemann wrote:
Billy M wrote:
Pack it full of grease and put it back in! :-)r

I personally would replace that. That's pretty bad.

Billy



was thinking this...
http://www.driveshaftparts.com/cv-joints-shafts/jeep-front-driveshaft-cv-joint/prod_430.html



that is who I used , and mine was worst , you do not need a new shaft

Author:  painemann [ Wed Apr 10, 2013 9:46 am ]
Post subject:  Re: Rebuild front drive shaft, too late? Same as gas jeep?

ibedonc wrote:
painemann wrote:
Billy M wrote:
Pack it full of grease and put it back in! :-)r

I personally would replace that. That's pretty bad.

Billy



was thinking this...
http://www.driveshaftparts.com/cv-joints-shafts/jeep-front-driveshaft-cv-joint/prod_430.html



that is who I used , and mine was worst , you do not need a new shaft



Good to know, thanks... looks like it is just spline, I'll give it a shot.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/