| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rockers, is it a good buy? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=75175 |
Page 1 of 1 |
| Author: | TennesseeCRD [ Tue May 07, 2013 1:30 pm ] |
| Post subject: | Rockers, is it a good buy? |
http://www.ebay.com/itm/171000751803?it ... 736wt_1087 I've messaged the seller. It says brand new but below it talks about used parts. Also in the compatability chart it says it doesn't fit my jeep but everything else tells me it does. Anybody bought from these guys before? Thanks, Steve |
|
| Author: | dieseldoesit [ Tue May 07, 2013 3:10 pm ] |
| Post subject: | Re: Rockers, is it a good buy? |
Considering you can get them from idparts for less money, I would say no, it isn't a good buy. http://www.idparts.com/catalog/product_ ... ts_id=3065 |
|
| Author: | audiboy86 [ Tue May 07, 2013 3:59 pm ] |
| Post subject: | Re: Rockers, is it a good buy? |
They don't even look like the ones used by our CRDs they look like they are cast and not stamped. And the lifters look wrong even. |
|
| Author: | Hexus [ Tue May 07, 2013 4:56 pm ] |
| Post subject: | Re: Rockers, is it a good buy? |
I got mine from him when I bought mine, but that is when IDParts had them listed for over $800. He's legitimate, those are the right rocker arms in the pictures too, don't know what you meant about looking "stamped." The lifters are correct as well... The used parts thing is a disclaimer, I talked with him about them and they showed up at my house in the original Mopar Box / VM Baggies. He's 100% legitimate but if you're here in the US as your name suggests, then you should get them from ID parts before the interstate sales tax goes into effect. ROFL. If you're doing them yourself you can feel free to message me as I just did mine and I'll give you some tips and pointers. I'm near Nashville by the way. |
|
| Author: | audiboy86 [ Tue May 07, 2013 7:32 pm ] |
| Post subject: | Re: Rockers, is it a good buy? |
The rockers I had in my hand last week from IDParts where stamped steel by what I could tell and not cast like a lot of diesel lifters I have seen. And maybe it is just the picture but those looked cast to me. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|