Help. I have engine code P1265 showing on my BT1 scanner. I have searched the forums and thought it was a bad glow plug, but I also found a topic (here) on how to test the glow plugs. They all test fine. I hate the dealer here and I am really reluctant to take it in. Anyone able to help?

Vehicle 2006 Jeep Liberty CRD

How exactly did you test the glow plugs? Did you measure the resistance of a good one and compared it with the old one that throws the code? Did you take it out and test it? I would bet it is still a glow plug...

_________________
2005 kj CRD, samco, suncoast tc, provent, Kennedy lift pump, GDE ECO full torque, 2nd gen filter head, 245/70/16 a/t tires, mopar light bar, fumoto oil valve, OEM Skid Plates, ARB Front bumper and HD OME, tru cool LPD47391 40k GVW tranny cooler (stock cooler delete), FF Dynamics e-fan and shroud, rocker arms replaced, HDS2 190F thermostat.

The attached link should help.

viewtopic.php?f=98&t=70159

_________________
2005 Jeep Liberty Limited CRD, JBA coilovers-4.5 Arms, 5xMoab's with 265-75-16 Mickey Thompson Baja ATZ, Safari snorkel, Suncoast T/C, GDE Hot tune, Mandrel bent CAC Tubes, EHM to airbox, Mopar skid's, Fumoto Drain Valve, 3% Tint, ARB front bumper, Full set of Miller tools (9599) to loan within my immediate vicinity.