tdiguy wrote:
Does anyone have dimensions for the round plug to put in the exhaust maninfold where the egr pipe hooks up to the exhaust manifold?
You can tap the manifold with a pipe plug tap and then screw a pipe plug into it to seal if off. (It is hard to get to with the exhaust manifold on the engine while it is installed in the vehicle.
or
You can simply make one out of thick steel washer, put a bolt/nut in it, grid it down to the correct size to fit the OEM clamp, and then spot weld the bolt/nut so it cannot come apart.
That's what I did on mine and have been running it like that since 2013 with no issues.
If you need one made for you, PM me. I can make you one.
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve