Remove the heat shield (2 bolts), unbolt the electrical connections, remove the 2 mounting bolts, pull out starter.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| starter removable http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=76958 |
Page 1 of 1 |
| Author: | ibedonc [ Sat Oct 05, 2013 7:31 pm ] |
| Post subject: | starter removable |
I have seached and have not found anyone on here that explain STARTER removable , I see two bolts , are there more ? I have the jeep jacked up and do not have the skid plate on |
|
| Author: | Leeann [ Sat Oct 05, 2013 8:11 pm ] |
| Post subject: | Re: starter removable |
Remove the heat shield (2 bolts), unbolt the electrical connections, remove the 2 mounting bolts, pull out starter. |
|
| Author: | ibedonc [ Sat Oct 05, 2013 8:42 pm ] |
| Post subject: | Re: starter removable |
thanks so other then wiring connections there are only 2 bolts holding to the bell housing |
|
| Author: | Leeann [ Sat Oct 05, 2013 8:44 pm ] |
| Post subject: | Re: starter removable |
As far as I remember, yes. |
|
| Author: | CATCRD [ Sat Oct 05, 2013 9:58 pm ] |
| Post subject: | Re: starter removable |
Leeann wrote: Remove the heat shield (2 bolts), unbolt the electrical connections, remove the 2 mounting bolts, pull out starter. That looks like a gas engine. I think there are three on ours. |
|
| Author: | Leeann [ Sat Oct 05, 2013 10:01 pm ] |
| Post subject: | Re: starter removable |
Whoops. Didn't pay attention to which subforum i was in.... |
|
| Author: | CATCRD [ Sat Oct 05, 2013 10:22 pm ] |
| Post subject: | Re: starter removable |
No problem. To the original poster, check the 2006 service manual for the procedure, as the procedure for the removal on a diesel engine doesn't appear in the 2005 service manual. |
|
| Author: | ibedonc [ Mon Jan 20, 2014 5:38 pm ] |
| Post subject: | Re: starter removable |
so it turns out I do not have to remove my starter , after looking looking farther into the issue and I was going to jumper the solenoid , I found the wire off the connector , plugged it back in and it starts  no idea how it came off |
|
| Author: | flman [ Mon Jan 20, 2014 7:04 pm ] |
| Post subject: | Re: starter removable |
I do not remember remove the heat shield part? 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|