I found the vent hose off of the transfer case hanging out below the the bottom of the Libby. From the part drawing, it shows the vent hose connected to some sort of a connector that I would guess in turn is attached to the transmission tunnel or firewall. I can't find that rascal anywhere. Anyone know where this connector might be located?

For the time being I tie-wrapped it to the transmission dipstick tube so that it comes up part way on the back side of the engine.

There is a hose fitting on the t-case. You can feel for it, bit it would be more easy to see by unbolting the cross member and letting things droop down a bit. You can probably feel by hand, but there isn't a lot of space. The hose then ran over the top of the transmission to the trans dipstick. It's been a while and I remember there being some way to secure it, but I don't remember exactly how that was done.

The fitting on the transmission vent points toward the drivers side and may or may not have a vent hose connected. I think the one on the transfer case points forward. I do remember the hose being slipped on and having a clamp on it.

Sent from my DROID RAZR using Tapatalk