starter removable

ibedonc · **Joined:** Mon Feb 12, 2007 2:40 pm **Posts:** 236

I have seached and have not found anyone on here that explain STARTER removable , I see two bolts , are there more ?

I have the jeep jacked up and do not have the skid plate on

Leeann · **Joined:** Thu Mar 14, 2013 9:19 pm **Posts:** 523

Remove the heat shield (2 bolts), unbolt the electrical connections, remove the 2 mounting bolts, pull out starter.

ibedonc · **Joined:** Mon Feb 12, 2007 2:40 pm **Posts:** 236

thanks so other then wiring connections there are only 2 bolts holding to the bell housing

Leeann · **Joined:** Thu Mar 14, 2013 9:19 pm **Posts:** 523

As far as I remember, yes.

CATCRD · **Posted:** Sat Oct 05, 2013 9:58 pm

Leeann wrote:

Remove the heat shield (2 bolts), unbolt the electrical connections, remove the 2 mounting bolts, pull out starter.

That looks like a gas engine. I think there are three on ours.

Leeann · **Joined:** Thu Mar 14, 2013 9:19 pm **Posts:** 523

Whoops. Didn't pay attention to which subforum i was in....

CATCRD · **Posted:** Sat Oct 05, 2013 10:22 pm

No problem.

To the original poster, check the 2006 service manual for the procedure, as the procedure for the removal on a diesel engine doesn't appear in the 2005 service manual.

ibedonc · **Joined:** Mon Feb 12, 2007 2:40 pm **Posts:** 236

so it turns out I do not have to remove my starter , after looking looking farther into the issue and I was going to jumper the solenoid , I found the wire off the connector , plugged it back in and it starts :pepper:

no idea how it came off

flman · **Posted:** Mon Jan 20, 2014 7:04 pm

I do not remember remove the heat shield part? :wink:

starter removable

Who is online